FIG 188R 188R CPVC Two Hole Standoff Hanger and Restrainer

188 R

Description

Size Range: 3/4" through 2"

Material: Carbon Steel

Finish: Pre-Galvanized per ASTM A653

Service:

  • Hanger and surge restraint for horizontal CPVC piping when installed on the top, bottom, and side of the supporting structure.
  • Guide for vertical CPVC piping when installed on the side of the supporting structure.
  • Horizontal and vertical seismic restraint per NFPA 13-2016 requirements.
  • Listed with hardware provided on structural wood beams and composite wood beams (1" minimum). Listed with steel (18ga minimum) with two (2) #14x1" or 1/4"x1" hex washer head self-drilling TEK screws. For wood structures with less than 1” thickness, wood blocks may be placed on the backside of the wood structure. #10x1" fastener provided must be fully engaged in the wood block.
  • May be installed with concrete, steel structural members, and other structural members with fasteners which comply with the requirements of NFPA 13.

Approvals: cULus Listed

Patents: No. 6,648,278

Installation: 

  • Snap hanger over pipe. If needed, squeeze strap back around pipe.
  • CPVC pipe must be allowed to slide freely through the Fig. 188R.
  • Secure hanger to mounting surface with screws provided or with listed fasteners.  

Features: 

  • Beveled edge design helps protect the CPVC pipe from any rough surface and eliminates pipe abrasion.
  • Easily attaches to wood structure with #10 x 1" hex washer head self-threading screw supplied with product. No pre-drilling required.
  • Bottom of pipe is offset 1-1/2" from the structure. Eliminates wooden spacer blocks.

Ordering: Specify CPVC pipe size, figure number and description.

Listings, Approvals & Certifications