Size Range:

  • Service Pipe: 2-1/2" through 8" Sch. 10 and Sch. 40 IPS.
  • Service Pipe: 2-1/2" through 6" Flow Pipe.
  • Brace Pipe: 1" or 1-1/4" Sch. 40 IPS

Material: Carbon steel clamp, ductile iron brace connector

Finish: Plain or Zinc Plated

Service: Used to rigidly brace piping systems subjected to sway and seismic disturbances. Pipe clamp component of Anvil's 700 series sway brace assembly. Can be utilized as either a lateral brace clamp or a longitudinal brace clamp.

Approvals: UL and ULC Listed (UL 203A:2009), and FM Approved (FM 1950:2010). Complies with seismic bracing requirements of NFPA-13. Office of Statewide Health Planning and Development (OSHPD) State of California approved.


  • No threading of bracing pipe
  • Functions as a lateral or longitudinal brace clamp

Installation Instructions:

  1. Installation of the pipe must be at a minimum 6" away from a pipe joint.
  2. Position pipe clamp at desired location and loosely tighten the clamp hex bolts. Ensure that the spacer and brace pipe connector are positioned between the pipe clamp ears.
  3. Place the Schedule 40 brace pipe into the brace pipe connector until it bottoms out.
  4. Tighten shear bolt until the head shears off. Then position the brace pipe to the appropriate angle. The use of an impact wrench is not recommended.
  5. Tighten the pipe clamp hex bolts equally and alternately until metal-to-metal contact is achieved with the following torque values. Clamp Bolt Minimum Torque Values: 2-1/2" thru 3" Dia. Clamps (80 Ft-Lbs), 4" & 5" Dia. Clamps (100 Ft-Lbs), 6" Dia. Clamp (120 Ft-Lbs), 8" Dia. Clamp (140 Ft-Lbs).
  6. Note: For 6" and 8" service pipe, a thread lubricant such as Gruvlok® Xtreme™ Lubricant should be used to ease assembly of pipe clamp hex bolts and nuts.

Ordering: Specify service pipe diameter x brace pipe diameter, figure number, name and finish.


Product Image

Product Data Sheets

Technical & CAD Data

Not available for this product

Listings, Approvals & Certifications